Back to Blog
Buying Guides 3 min read

Will a Pop-Up X Fit in My Garage?

Before you order, check the height of your truck with the camper and roof accessories installed, then measure the actual clearance along the way into your garage.

A WanderWheels archive photo showing a truck camper with the roof in its travel position. Use your own installed build to verify height.

Compare the installed truck and camper’s highest point with the lowest usable clearance along your route into the garage. Take the truck measurement with the roof fully closed and your travel accessories in place. If the driveway slopes or the gap is tight, ask your installer to review the approach before you try to drive in.

Start with the installed travel height

A camper can fit your truck bed and still be too tall for your garage. For the WanderWheels Pop-Up X, ask for an estimate tied to your truck and the configuration you’re considering. The height that matters is measured from level ground to the highest point on the assembled truck and camper with the roof down. How far the roof lifts at camp is a separate measurement.

If your quote gives only the camper’s height, ask where that measurement starts and whether it includes the highest accessory. An installed bed mat or spacer can change where the camper sits. Truck tires and suspension also affect installed height. Check anything that stays mounted during travel, such as rack bars, a roof vent or an air conditioner if fitted. The highest point may be an accessory rather than the roof panel.

Measure the route through the garage

Open the door fully and measure from the floor to the lowest obstruction over the path the truck will use. Look at the door’s lower edge, weather seal, header and any track or opener hardware in that path. Use the actual clear opening. A door’s advertised size can differ from the room you have beneath the fully opened door.

Keep checking beyond the threshold. A beam, light or low opener rail farther inside can limit where you park. Check the usable width for the mirrors and the depth for the whole truck and camper. If you plan to load gear in the garage, leave room behind the truck for the camper door to open.

Four checks before you order

Swipe or use the arrow keys to read the full table.

CheckWhat to recordWhen to verify
Closed travel heightGround to the highest point, including mounted accessories.Request a build-specific estimate. Confirm it on the installed truck.
Door and interiorLowest obstruction along the route, plus usable width and depth.Measure with the door fully open, before ordering.
Driveway approachSlopes, a raised threshold or a change in grade near the opening.Show the installer a side-on photo and ask them to assess a tight approach.
Room to raise the roofOpen-roof height and space for movement beneath overhead hardware.Check separately if you plan to open the roof indoors.

If the driveway slopes or the gap is small

A change in grade can tilt the truck as it crosses the threshold and bring a corner of the camper or a roof accessory closer to the opening. A positive difference between two measurements on level ground alone cannot confirm clearance on a sloped approach. Ask the installer to assess the path and the margin for your setup. Verify the actual installed height before the first entry, then recheck it after changes to tires, suspension or roof equipment.

Ask for the height with your build options

When you have your truck details, door clearance and the accessories you expect to carry, ask which measurements can be confirmed before ordering and which need a check after installation. If you’re still checking whether the camper fits the pickup itself, start with the truck-bed measurement guide. For the rest of the purchase, use the camper quote guide to compare options and shipping on the same basis.

Considering a Pop-Up X for a garage with limited clearance? Ask about the estimated installed travel height for your truck and the options you’re considering.

Ask about Pop-Up X fit
Pop-Up X community popup

Stay in the loop

join the community

Get product updates, release announcements, event invites, and direct contact from our team.